FAQ

Preventing Phantom or “Ghost” Calls on SIP Devices

What causes phantom calls?

SIP phones and analogue telephone adapters (ATAs) can receive unwanted calls when they are reachable from the internet and configured to accept direct IP-to-IP calls. Automated scanning systems can send unauthorised SIP call requests directly to the device, causing repeated ringing even though no legitimate call has been placed to your telephone number.

These calls may display unusual caller IDs such as 100, 700, 800, 900 or 1000 and can occupy lines or disrupt a connected telephone system.

Calls that reach your equipment directly in this way bypass IXICA’s network and are not delivered through your IXICA SIP trunk. The solution is to restrict which incoming call requests your equipment accepts.

Recommended settings for Grandstream ATAs

Log into the ATA’s web interface using administrator access and configure the following:

Settings section Setting Recommended value
Advanced Settings Disable Direct IP Call Yes
FXS Port / SIP Profile Validate Incoming SIP Message Yes
FXS Port / SIP Profile Check SIP User ID for Incoming INVITE Yes — optional; see below
FXS Port / SIP Profile Allow Incoming SIP Messages from SIP Proxy Only Yes

Apply the relevant settings to every active FXS port or SIP profile. Menu locations and wording vary by model and firmware. On models that display Enable Direct IP Call instead, set that option to No.

Important: The Check SIP User ID for Incoming INVITE option checks whether an incoming call is addressed to the configured SIP user ID. Certain configurations may use a different destination identifier for legitimate calls. If normal incoming calls stop working after enabling this option, change only this optional setting back to No, apply the change and test again.

Save and apply the changes, reboot the ATA if required, and test normal incoming and outgoing calls. Rebooting alone does not correct the configuration that allows phantom calls.

Additional protection and troubleshooting

Keep the ATA’s firmware current, use a strong administrator password, and have your IT provider review firewall rules to prevent unsolicited internet traffic from reaching the device. Any SIP access restrictions must continue to allow IXICA’s authorised service addresses.

An unusual caller ID alone does not prove that a call bypassed IXICA. If the problem continues, contact IXICA Support with the affected telephone number, example call dates and times, and the ATA model. These details help distinguish direct-to-device phantom calls from unwanted calls arriving through the telephone network.

Share

Back to all FAQ answers